Portable Electromagnetic Automatic Drilling Machine
- FM-35EDL Comes with drilling force control unit for Auto-feeding:
When drill bit is worn out, this unit will drive feeding intermittently or stop feeding. Once feeding becomes difficult while making a hole, please replace a new drill bit or re-sharpen the worn out one in order to protect both drilling tool and machine body from being damaged.
- FM-35EDL Comes with two intermittent breaking rates for breaking chips:
Choose different feeding rates according to different drill bits and material to perform Auto-feeding operation. This device can break chips intermittently and discharge them while Auto-feeding is processing, so that chips would not roll on drill bit.
Easier to discharge chips.
- The machine body is with height adjustment. It’s suitable for both lone and short annular cutters as well as general chuck which is for holding drill with straight handle.
- The general chuck is applicable for holding drill which is with straight handle for drilling smaller holes(from 8-13mm).
|Power (AC)||110V-120V 50/60 Hz|
|220V-240V 50/60 Hz|
|Motor Rated Output||110V-120V 1010W|
|Motor Rated Ampere||110V-120V 9.2A|
|No Load Speed||720min-1|
|Hole -cutting Capacity||14 to 35mm|
|Drill Capacity||8 to 13mm|
|Magnet Holding Power||800kgf|
|Standard Fitting|| Chuck of drill :13mm x 1 set
Pilot Pin 35L x1 piece
Pilot Pin50L x1piece
Coolant tank set x1 set
Allen key 6mm x1piece
* These specifications and shape may be changed for improvement without prior notice.