Portable Electromagnetic Automatic Drilling Machine
- FM-35EDL Comes with drilling force control unit for Auto-feeding:
When drill bit is worn out, this unit will drive feeding intermittently or stop feeding. Once feeding becomes difficult while making a hole, please replace a new drill bit or re-sharpen the worn out one in order to protect both drilling tool and machine body from being damaged.
- FM-35EDL Comes with two intermittent breaking rates for breaking chips:
Choose different feeding rates according to different drill bits and material to perform Auto-feeding operation.
This device can break chips intermittently and discharge them while Auto-feeding is processing, so that chips would not roll on drill bit.
Easier to discharge chips.
- The FM-35EDL model is with stopping device for auto withdrawing.
The annular cutter will withdraw to the origin and stop running automatically when drilling hole is finished in auto feeding mode.
It’s easy and safe for the operator as well as increase efficiency.
- The 19mm shank with short type twist drill bit can be used for drilling hole which is smaller than 16mm.
|Power (AC)||110V-120V 50/60 Hz|
|220V-240V 50/60 Hz|
|Motor Rated Output||110V-120V 1010W|
|Motor Rated Ampere||110V-120V 9.2A|
|No Load Speed||720min-1|
|Hole -cutting Capacity||Ø17 to 35mm|
|Drill Capacity||Ø6 to 16mm|
|Magnet Holding Power||800kgf|
|Standard Fitting|| Connecter of hole
Pilot Pin50L x1piece
Coolant tank set x1 set
Allen key 6mm x1piece
* These specifications and shape may be changed for improvement without prior notice.